Knife for clinker puller - High quality - Spare blade for ORIT

Does removing tiles or clinkers no longer go so easily with your stone puller? Chances are the blades are worn out. Worn blades are blunter and slide less easily in the joints between the stones. Replace the blades with this spare blade from Talen Tools, to get your job done quickly and competently again. The blade is suitable for the adjustable tile and clinker pullers from Talen Tools. Due to the contact with rugged tiles and clinkers, the development of this knife focused on a long life. The forged and hardened metal is wear-resistant and resistant to corrosion.

Replace blade of clinker puller
You replace the blades very easily. Due to the wide opening already in the design of the blade, you easily tighten the blade again by tightening the bolt . Does the bolt of your old knife still look good? Then it is possible to use this bolt for the new knife as well. This knife is also suitable as replacement for an ORIT stone puller. To make this knife last even longer, it is recommended to briefly brush off the knife after use or to clean it with a damp cloth. This will prevent residual material from sticking to the blades. This material can cause the knife to wear faster on the next job. So make sure to maintain it adequately.

How does a stone puller work?
The narrow blades are sharp and narrow enough to poke into the joints of the ground. Determine the width of the tile or clinker beforehand. When you set the puller to the correct width, you will notice that the blades clamp firmly around the tile. With a clinker puller, you then smoothly pull up the tile. A clinker puller makes it a lot less intensive to remove clinkers from the ground. Save yourself physical pain and make sure you have the right tool. Moreover, you will also save energy this way.

Main advantages of the Talen Tools spare blade

- Suitable for the adjustable clinker and stone pullers from Talen Tools and ORIT
- Of high-quality forged steel for long life
- Easy to assemble